Tamiya 300060752 - 1:72 Vought F4U-1D Corsair
Artikel-Nr.: 300060752-tam
Mit Mausrad vergrößern / verkleinern
Artikel mit Tiefpreis-Option
Tamiya 300060752 - 1:72 Vought F4U-1D Corsair
Artikel
Artikelbezeichnung: 1:72 Vought F4U-1D Corsair
Designed around the new Pratt & Whitney 2,000HP radial engine and
tuning the largest propeller ever attached to a fighter plane, the
Vought F4U Corsair became a legend in its own time. The F4U-1 was the
first production version of the Corsair. It had an inverted gull wing
and a production version of the Corsair. It had an inverted gull wing
and a framed canopy with a flat top. However may problems were found
soon. For example, the port wing stall often gave the Corsair unstable
landing. Anther problem was poor visibility because of its long nose and
framed canopy. Therefore F4U-1A: the cockpit was raised about seven
inches, the framed canopy was replaced with a semi-bubble design canopy,
and the taller tail wheel strut was equipped was introduced. F4U-1D
with clear vision canopy on frameless was introduced later for more
visibility. Also the F4U-1D had two pylons under the center wing section
that could carry the bombs up to 1,000 ponds and the napalm. Furthermore
5 inch rockets could be carried under each wing. Therefore in1944, the
F4U-1D was formally deployed as the first carrier based aircraft of
Corsair series. Beginning by placing the F4U 1D as Marine squadrons
VMF-124 and VMF 213 aboard the ESSEX on the way to the Phillippines, the
F4U-1D was used for attacking Japan as the first operation from U.S.
Navy in 1945. About 3,700 amounts of F4U-1D were produced, then it held
an established position from U.S. Navy because of its ability and reliance.
Detailierter Plastikmodellbausatz des Modells
Vought F4U-1D Corsair
im Maßstab 1:72
| Größe: | Maßstab 1:72 |
| Hersteller: | Tamiya |
| Produkttyp: | Plastikmodellbau |
| Kategorie: | Tamiya Maßstab 1:72 |
SIMBA-DICKIE-Vertriebs-GmbH
Werkstraße 1, 90765, Fürth, Deutschland
0911-9765-100, service.simba-dickie.com
